Refill Instructions

Refilling the Resin in your Water Deionizer

Follow these step-by-step instructions on how to refill and replace your resin in your water deionizer. These instructions are the same for all water deionizer models.

Video Refilling Instructions:

ddd

Written Refilling Instructions:

Step A: When output water quality has exceeded predetermined level, or when spotting occurs, DI water is no longer being produced. Shut off the water supply and remove tank head.

Step B: Empty resin into a waste container and rinse out tank. Dispose in accordance with federal, state, and local regulations.

Step C: Return distributor tube into the tank and place the blue cap over top of tube. Place funnel into top of the tank.

Step D: Slowly pour or scoop resin into the tank. Shake or tap tank to get all of the resin bedded. Tank should be filled to approximately three inches from the top.

Step E: Remove the funnel and blue cap. Replace tank head. Make sure all O-rings are properly seated. Insure seating areas are free from foreign material; apply silicone lubricant to surface of O-rings.

Step F: Connect the water source to the inlet of the deionizer. Turn on water and flush out the system for 10-15 minutes (gets out all the resin dust). The unit will now produce deionized water.